4
DR
®
2-CYCLE TILLER CULTIVATOR
Operating the Tiller/Cultivator Safely
Safety with Gasoline-Powered Machines
Clear the work area of objects that might jam or wrap around the Tines such as glass, large sticks, stones, metal objects, wire,
rope, and string-like materials. Use on these objects could damage the DR 2-CYCLE TILLER CULTIVATOR and/or cause injury.
Do not touch the muffler and Engine when the machine is in use as they become very hot and can cause severe burns.
The Engine should always be off before adjusting the Wheel Height or Drag Stake.
Never, under any conditions, remove, bend, cut, fit, weld, or otherwise alter standard parts on the DR 2-CYCLE TILLER
CULTIVATOR. This includes all shields and guards. Modifications to your machine could cause personal injuries and property
damage and will void your warranty.
Do not operate the machine when under the influence of alcohol, drugs, or medication.
Use the DR 2-CYCLE TILLER CULTIVATOR only in daylight.
Do not hurry or take things for granted when using the DR 2-CYCLE TILLER CULTIVATOR. When in doubt about the machine
or your surroundings, stop the machine and take time to look things over.
Do not use this machine around large roots and surface rocks that you cannot remove prior to use.
Do not use this machine around underground pipes and wiring.
Prior to removing material from the Tines by hand, stop the Engine and remove the Spark Plug wire.
Gasoline is a highly flammable liquid. Gasoline also gives off flammable vapor that is easy to ignite and cause a fire or explosion.
Never overlook the hazards of gasoline and always follow these precautions:
Never run the DR 2-CYCLE TILLER CULTIVATOR Engine in an enclosed area or without proper ventilation as the exhaust from
the Engine contains carbon monoxide, this is an odorless, tasteless, and deadly poisonous gas.
Store all fuel and oil in containers specifically designed and approved for this purpose and keep away from heat, open flame,
and out of the reach of children.
Mix the oil and gasoline outdoors and then fill the Fuel Tank outdoors with the Engine off; allowing the Engine to cool
completely. Do not handle gasoline if you or anyone nearby is smoking, or if you are near anything that could cause it to ignite
or explode. Replace the Fuel Tank and Fuel Container Caps securely.
If you spill gasoline, do not attempt to start the Engine. Move the machine away from the area of the spill and avoid creating
any source of ignition until the gas vapors have dissipated. Wipe up any spilled fuel to prevent a fire hazard and properly
dispose of the waste.
Allow the DR 2-CYCLE TILLER CULTIVATOR Engine to cool completely before storing in any enclosure. Never store the
machine with fuel in the tank or with fuel in a container near an open flame or spark such as a water heater.
Never make adjustments or repairs with the Engine running. Before making an adjustment or repair, shut off the DR 2-CYCLE
TILLER CULTIVATOR Engine, wait five (5) minutes to cool, then disconnect the spark plug wire and keep the wire away from
the spark plug to prevent accidental starting.
Never check for an ignition spark with the Spark Plug or Spark Plug wire removed. Always use an approved spark tester.
To reduce fire hazard and keep the Engine from overheating, keep the Engine and Muffler area free of debris or any other
combustible material.
Never operate the Engine without the Muffler. Inspect the Muffler periodically and replace if necessary.
Never operate the Engine with the Air Filter or Cover over the Carburetor air intake removed, except for adjustment. Removal of
such parts could create a fire hazard. Do not use flammable solutions to clean Air Filter.
Always check Fuel Lines and fittings frequently for cracks or leaks, replace if necessary.
Replace rubber Fuel Lines and Grommets when worn or damaged, but do not use over five (5) years.
