Copyright © 2001-2018, Dr Robot Inc. All Rights Reserved.
www.DrRobot.com
V25.08.18.Q
- 14 -
Recharging
Jaguar robot uses high performance LiPo batteries. Extreme caution is needed
when dealing with this type of battery, explosion and damage could occur.
Please read the Charge Station manual first and follow all the safety rules before
proceeding further.
1) Turn off the robot
2) Loose the screws of Battery Box, disconnect the 2-Pin Tamiya connector and take the Battery Box out.
3) Power on the Charge Station. Use
to make sure "LiPo BALANCE" is displayed on the LCD screen. If not,
use "Type/Stop" button to change battery type to "LiPo Battery" and press
to set charging mode to “LiPo BALANCE” .
4) You can use
+
/
+
buttons to change the charge
current, DO NOT exceed the 2A charging current and do not modify the battery voltage. It should be "22.2V
(6S)" for Jaguar robot.
5) Connect the charging 7-Pin, 3-Pin & 2-Pin connectors to charger as below images.
6) Press
button for few seconds, the charge station will check the battery and display what the reading is. It
should be same as your settings above.
7) If everything is right, you can press
button again to start charging.
8) Press
to switch the display to show the battery status. The display
should show each battery reading as below image.
*
Note
: If any battery reading is missing, please turn off the charging station and turn the Power switch to “OFF”,
and check the 7-pin connector, make sure it is connect well.
9) Keep the charger away from children and pet at all time! Never leave the charger unsupervised when it is
connected to its power supply. For more detail about charger station operation, warning and error message,
maintenance and safety message, please refer to “Intelligent Digital Balance Charger Operating Manual”.
