14
D R
®
HORIZONTAL/VERTICAL LOG SPLITTER
Take extra care when raising and lowering the beam as it is very heavy.
Having a second person assist with raising or lowering the beam is
recommended to prevent injury. Be sure to keep hands away from any
possible pinch points.
Installing the Log Trays
Parts Supplied in Hardware Kit #6 (
Figure 23
):
Item # Part
# Description
Qty
1 ............. 33707 .............. Bolt, Hex, M12 X 45 ................................... 4
2 ............. 30252 .............. Washer, Flat, M12 ....................................... 8
3 ............. 30253 .............. Nut, Nylon Lock, M12 ................................. 4
4 ............. 33708 .............. Bolt, Hex, M10 X 30 .................................... 4
5 ............. 30250 .............. Washer, Flat, M10 ....................................... 8
6 ............. 30249 .............. Nut, Nylon Lock, M10 ................................. 4
Compare the contents of the Hardware Kit #6 with the “Parts Supplied” list
above. If you have any questions please contact us at www.DRpower.com or
call 1-800-DR-OWNER (376-9637) for assistance.
Note:
When installing the Bolts, Washers, and Locknuts, install the Washers so that
one Washer is against the head of the Bolt, and the other Washer is against the
Locknut.
1.
Tighten the Hardware of the loosely assembled Log Trays using a 16mm
Wrench on the Bolts and a 17mm Wrench on the Locknuts (
Figure 24
).
2.
Get help from another person to lower the beam to the horizontal position.
Refer to the “Beam Operating Positions” Section in Chapter 3 for detailed
information on raising and lowering the Beam.
3.
Position a Log Tray onto the Beam as shown and loosely secure the End
Plate with two M10 x 30 Bolts, four M10 Flat Washers, and two M10
Locknuts (
Figure 25
). Repeat this step for the second Log Tray.
4.
Loosely secure the bottom supports to the beam with four M12 x 45 Bolts,
eight M12 Flat Washers, and four M12 Locknuts (
Figure 26
).
5.
Tighten the M12 Hardware using an 18mm Wrench on the Bolt and a 19mm
Wrench on the Locknut.
6.
Tighten the M10 Hardware using a 16mm Wrench on the Bolt and a 17mm
Wrench on the Locknut.
Figure 25
Log Trays
M10 Bolts,
Flat Washers,
and Locknuts
Figure 24
Hardware
1
2
3
4
5
6
Figure 23
Figure 26
M12 Bolts, Flat
Washers, and
Locknuts
