DR
®
Power Equipment
7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1
1-800-DR-OWNER (376-9637) • www.DRpower.com
©
2009 CHP, Inc. 253691
Daily Checklist for the DR POWERWAGON-PRO
To help maintain your DR for optimum performance, we recommend you follow this checklist each time you use
your machine.
[ ] OIL: With the machine on a level surface, remove the Oil Fill Cap and check the oil level. Fill the reservoir
according to the Dipstick with SAE30 HD motor oil.
[ ] GAS: Fill the Fuel Tank with fresh, unleaded gasoline.
[ ] ENGINE: It is very important to keep the Engine clean. Remove grass and other debris from the Engine
Cooling Fins and Debris Guard. A dirty Engine retains heat and can cause damage to internal
Engine components.
[ ] BELT: Check the Belt for wear, proper alignment and tension.
[ ] AIR FILTER: A clean Air Filter will mean a much easier starting and cooler running Engine. Please refer to your
Engine Owner's Manual for instructions on cleaning the Air Filter.
[ ] TIRES: Check the Tires for wear and proper inflation.
End of Season and Storage
NOTE:
Please refer to the Engine Owner's Manual for Engine-specific procedures.
•
Change the oil; this will help to eliminate sludge and acids in the Engine. For winter use, use SAE 5W – 30W.
•
If your DR POWERWAGON-PRO will be idle for more than 30 days, we recommend using a gas stabilizer. This
will prevent sediment from gumming up the carburetor. If there is dirt or moisture in the gas or tank, remove it
by draining the tank. Completely fill the tank with fresh, unleaded gas and add the appropriate amount of
stabilizer or gasoline additive. Run the Engine for a short time to allow the additive to circulate.
•
Remove the Spark Plug and pour about 1 ounce of motor oil into the cylinder hole. Replace the Plug and pull
the Recoil Starter Rope until you feel strong resistance. This will coat the piston and seat the valves to prevent
moisture buildup.
•
Clean and/or replace the Air Filter(s).
•
Clean dirt and debris from the cylinder head cooling fins, carburetor linkage, blower housing, rotating screen,
and muffler area of the Engine.
•
Check to make sure the operator controls are moving freely. Lubricate the Throttle Lever, Parking Brake Lever,
and Key Switch with SAE 30 Oil if necessary. See page 20.
•
Electric starting models: Remove the Battery and keep it in a cool, dry place when the DR POWERWAGON-PRO
is in storage. We suggest charging the Battery once a month while the DR is stored, and again before you are
ready to start the new season. This will help the Battery maintain its charge all season. See page 19.
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, SET THE
PARKING BRAKE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK
PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG.
