7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1
©2016 Country Home Products, Inc. All rights reserved
321931A
Daily Checklist for the DR ROTO-HOG Premier Power Tiller
To help maintain your DR ROTO-HOG Premier Power Tiller for optimum performance, we recommend you follow this checklist
each time you use your machine.
[ ] OIL: With the machine on a level surface, remove the Oil Fill Cap and check the Oil level. Fill the reservoir until the Oil
reaches just below the threads with SAE 30 HD motor oil. See page 9.
[ ] GAS: Fill the Gas Tank with fresh, unleaded gasoline. See page 9.
[ ] ENGINE: It is very important to keep the Engine clean. Remove dirt and other debris from the Engine Cooling Fins. A dirty
Engine retains heat and can cause damage to internal Engine components.
[ ] HARDWARE: Check all nuts and bolts to be sure that the components are secure.
[ ] FRAME: Check all welds to be sure that the Frame is intact and secure.
[ ] TINES: Make sure that the Tine Assemblies and Debris Shield are free of accumulated debris.
End of Season and Storage
NOTE:
Please refer to the Engine Owner’s Manual for Engine-specific procedures.
Change the Engine oil.
If your DR ROTO-HOG Premier Power Tiller will be idle for more than 30 days, we recommend using a gas stabilizer. This will
prevent sediment from gumming up the Carburetor. If there is dirt or moisture in the Gas or Tank, remove it by draining the
Tank. Completely fill the Tank with fresh, unleaded Gas and add the appropriate amount of stabilizer or gasoline additive. Run
the Engine for a short time to allow the additive to circulate.
Remove the Spark Plug and pour about 1 ounce of motor oil into the cylinder hole. Replace the Plug and pull the Recoil Starter
Rope until you feel strong resistance. This will coat the Piston and seat the Valves to prevent moisture buildup.
Clean or replace the Engine Air Filter. Reference the Engine Owner’s Manual.
Clean dirt and debris from the Engine Cylinder Head Cooling Fins, Debris Screen, and Muffler.
Clean out residual debris from the under the Debris Shield and Tine Assemblies.
Lubricate the Tine Assemblies and Wheels. See page 16-17.
TouchNotesup all rusted or chipped painted surfaces. Sand them lightly before painting.
Be sure all Nuts, Bolts, and Screws are securely fastened.
Inspect moving parts and the Tine Drive Belt for damage and wear; replace if necessary.
If possible, store your DR ROTO-HOG Premier Power Tiller inside, but not near an open flame or spark such as found in a
water heater.
After the DR ROTO-HOG Premier Power Tiller has cooled, cover the machine with a suitable protective cover that does not
retain moisture. Do not use plastic, as this material cannot breathe; it also allows condensation to form, which will cause your
machine to rust.
When performing any maintenance, you must first shut off the Engine; wait five (5) minutes to allow parts to cool and disconnect
the Spark Plug Wire, keeping it away from the Spark Plug.
When performing any maintenance, you must first shut off the Engine; wait five (5) minutes to allow parts to cool and disconnect
the Spark Plug Wire, keeping it away from the Spark Plug.
