CALL
TOLL
FREE
1-800-DR-OWNER
31
Removing and Replacing the Engine Oil
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, WAIT FIVE (5)
MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK PLUG WIRE, KEEPING IT AWAY
FROM THE SPARK PLUG.
BE CERTAIN TO FILL THE ENGINE WITH OIL BEFORE STARTING. SEE PAGE 18.
Tools & Supplies Recommended:
•
Flat Head Screw Driver
•
Vacuum Pump Oil Drainer
•
SAE 30 High Detergent, 20 oz. (0.60L)
NOTE:
Remove the oil when the engine is warm. Warm oil flows quickly and completely.
1. Using a Flat Head Screw Driver, remove the Oil Fill Cap and vacuum the oil from the Engine through
the Oil Fill (
Figure 10
on page 19) using a Vacuum Pump Oil Drainer.
2. Replace the oil by following the instructions on page 18.
NOTE:
Use SAE 30 High Detergent oil classified “For Service SF, SG, SH, SJ” or higher. Do not use special
additives. Other types of oil could cause problems operating your machine. Please refer to your Engine
Owner’s Manual for detailed oil information.
3. Reattach the Spark Plug wire.
NOTE:
Be sure to use environmentally safe disposal procedures for the used oil.
Summary of Contents for ROTO-HOG
