The supplied charger is designed to quickly charge Lithium-Polymer batteries as well as charge your
transmitter. It will fully charge the supplied lithium-polymer battery in approximately 1-2 hours.
This charger operates only from the supplied AC wall transformer.
Operation
:
1.
Connect the AC adapter to the AC power source(wall plugin). Connect the charger input to
the AC adapter. The green light will blink when power is applied to the charger with no bat-
tery connected.
2.
Connect the charger output to the battery using the supplied cable.
3.
When the green light goes out the battery is charged.
4.
To charge another battery, make sure you disconnect the AC power for 10 seconds to reset
the charger. Reconnect the AC power then connect battery.
To charge the transmitter, connect the barrel adapter on the charger to the charge socket located on
the side of the transmitter. The amber light will illuminate while the transmitter is charging. It will
not extinguish when the transmitter is charged. The transmitter will take 14-16 hours to charge
fully.
Note:
The Transmitter and the Lithium-Polymer packs can be charged simultaneously
Note:
The charger and the battery pack may get warm when charging. Disconnect the AC adapter
from AC power when the charger is not in use.
Caution:
Too much heat can damage battery packs. Wait for the batteries to cool after flying
before charging, and 15 minutes after charging before flying. It is advisable to have extra flight
batteries so you can always be flying!
WARNING:
Do not leave the transmitter on charge for
extended time (ie weeks); the internal NiCad
battery may be damaged.
Do not leave charging batteries unattended.
Do not charge batteries near flammable materials.
If battery becomes hot, disconnect it immediately.
Charging Draganflyer V Ti Batteries
Charging Draganflyer V Ti Batteries
14
DF5_manual_Imposed_Jan4_05 1/7/05 10:38 AM Page 30
Summary of Contents for DraganFlyer V Ti
Page 1: ...INVENTING THE FUTURE OF RADIO CONTROLLED FLIGHT...
Page 21: ...20...
