■
2
Dragon NaturallyClear — User’s Guide Supplement
After you complete the Add New Hardware Wizard, you may receive an
error message stating that Windows has not installed a driver for the device.
Despite this message, the installation has been successful.
You can use the USB System with multiple USB ports, but the first time
you plug the microphone into a new USB port you must repeat steps 3
and 4 above to install the appropriate device drivers.
While the USB protocol allows the “hot-swapping” of USB devices, we
recommend that you shut down Windows before unplugging the
device to avoid potential problems.
Testing the Microphone and Establishing
User files
When you install the USB System for use with Dragon
NaturallySpeaking or another Dragon Systems speech product, you
need to establish new user files and recalibrate the product’s audio
settings.
1
Start Dragon NaturallySpeaking.
2
Create a new user with the New User Wizard.
3
Select “USB Microphone” as your Dictation Source in the New User
Wizard.
4
Select “USB Audio Device” on the Choose your sound system dialog box.
If “USB Audio Device” is not listed as a selection, if you receive an
error message, or if the sound quality is evaluated as unacceptable for
speech recognition, see the following troubleshooting section.
5
Continue through the New User Wizard and then complete General
Training.
Note
After creating user files for the USB Audio Device, user files
created for other audio devices may not work. To correct the
problem, run the Audio Setup Wizard again for those user files.
O
Attention
Sup.bk Page 2 Thursday, August 10, 2000 5:12 PM
