DragonWave Inc.
18
Horizon Compact Plus Release 1.0.1
Wireless Ethernet Product User Manual
– Volume 2
5.3 Configuring SyncE
Procedure 5-1
Configuring syncE
All the commands in the following procedure are immediately invoked. There is no need to perform a
save mib
or
reset system
to make the feature active.
Required Action
Steps
login
Log in using the Super user, NAC or an Admin account.
View current status of SyncE
This command returns the current status of the SyncE feature
Sequence:
get synce status
press Enter
The system responds:
Synce mode is off
OR, if SyncE mode is active (example):
Synce mode :auto
Clock source :freerun
Acquisition status :acquired
Forced holdover :off
Add ports that are to be used
for SyncE to the member
group
This command allows you to add all the ports that are required to
handle SynchE into the member port group. Note that in order to
configure the ports that are to be the primary and secondary clock
sources, the ports must first be made part of the member port group.
Sequence:
set synce member port [p1|p2|p3|p4|wp1|freerun]
Example:
set synce member port p4,wp1
press Enter (note the
comma)
The system responds:
synce members:p4,wp1,freerun
Note: valid synce member port includes p1,p2,p3,p4,wp1;
freerun is always a synce member.
