Authentication
71
Horizon Compact Plus Release 1.0.1
Wireless Ethernet Product User Manual
– Volume 2
Procedure 12-3
Verify Authentication status
Use this procedure to verify the authentication action for the system.
Note:
To perform this procedure, you must be logged into the system as an NOC user.
Required Action
Steps
login
Log in using a NOC account.
View authentication status
Displays the authentication status between two corresponding Horizon
Compact Plus systems.
Sequence:
get peer authentication status
press Enter
The system responds:
Peer Authentication status:
[Authenticated|NotAuthenticated|ExplicitAuthenticationFailure]
Explanations:
If authentication has failed:
check the setting for action on authentication failure; and
ensure it is not set to Block Traffic (unless that is the intended action).
If authentication has not failed:
check to see if traffic is now flowing.
If traffic is flowing then the authentication has been re-established and
the system is operating normally
If traffic is not flowing, the problem is not due to authentication.
Configure authentication
failure
[block_traffic/pass_traffic]
Configures the action to take when authentication fails.
Sequence:
set peer authentication failure action [block_traffic/pass_traffic]
press Enter
The system responds:
System will [block_traffic/pass_traffic] on peer Authentication Failure.
get peer authentication failure action
press Enter (to verify action)
System will [block_traffic/pass_traffic] on peer Authentication Failure.
Save changes to mib
Saves the MIB to RAM. Perform this command to save setting
changes to non-volatile memory.
Sequence:
save mib
press Enter
The system responds:
MIB saved successfully.
This concludes the steps to verify the authentication status using the CLI manager.
