Rapid Link Shutdown
87
Horizon Compact Plus Release 1.0.1
Wireless Ethernet Product User Manual
– Volume 2
Required Action
Steps
Configure rls signal fault
parameters [fault period
msec] [fault threshold]
Sets the RLS signal fault monitor parameters. The RLS signal fault
settings are designed to detect and react to brief bursts of extreme
Rx Block error rates. The RLS signal fault detection and reaction
time is the quickest of the two RLS fault detection methods. RLS
signal fault detection works with the RLS signal degrade settings in
Advanced mode.
Sequence:
set rls signal fault parameters [fault period msec] [fault
threshold]
press Enter
Where
[fault sample period msec]
is the sample period to apply Fault
Threshold ratio
[fault threshold percentage]
is the ratio of 'fault sample period'
faulted before the link is shut down.
The system responds:
RLS Signal Fault Parameters: 1000 100
View current status of the
eoam RLS message option.
Use this command to view the current status of the eoam message
option for RLS events. Note that the eoam function must be enabled
before eoam commands will be invoked. See Volume 4 of this
manual for more information on eoam.
Sequence:
get rls shutdown policy
press Enter
The system responds:
RLS shutdown notification policy: eoam-msg
Change the current status of
the eoam RLS message
option.
This command enables or disables the option to send out an eoam
message when an RLS event is triggered. Note that the eoam
function must be enabled before eoam commands will be invoked.
See Volume 4 of this manual for more information on eoam.
Sequence:
set rls shutdown policy [port-down | eoam-msg]
Example:
set rls shutdown policy port-down
press Enter
The system responds:
RLS shutdown notification policy is set to :port-down
Save changes to mib
Saves the MIB to RAM. Perform this command save setting changes
to FLASH. This command does not restart the system and does not
put any new settings into effect. A system reset command will cause
settings in RAM to be programmed into FLASH and to take effect.
Sequence:
save mib
press Enter
The system responds:
MIB saved successfully.
