DranTech X
TRA
User’s Guide
47
Device and Measuring Parameters
A.diSP – analog display: select display mode
One of two different display modes can be selected for the analog dis-
play:
•
bArG: bar graph
•
Point: pointer
1nFo
Z
...
Z
SEt
rAtE
V
...
V
A
.
diSP
bArG / Point
UV
(bArG = default value)
APoFF – specified time for automatic shutdown and continuous ON
The instrument is switched off automatically if the measured value re-
mains unchanged for a long period of time, and if none of the keys or
the rotary switch have been activated before the specified time
“APoFF” (entered in minutes) has elapsed.
If the on setting is selected, the multimeter is set to continuous opera-
tion and
ON
appears in the display to the right of the battery symbol. In
this case, the multimeter can only be switched off manually. The “on ”
setting can only be cancelled by changing the respective parameter,
and not by switching the instrument off.
1nFo
Z
...
Z
SEt
rAtE
V
...
V
APoFF
10 ... 59 min on
UV
(10 minutes = default setting)
bEEP – set the limit value for continuity testing
1nFo
Z
...
Z
SEt
rAtE
V
...
V
bEEP
1,
10
, 20, 30, 40, 90
Ω
UV
(10
Ω
= default setting)
irStb – status of the infrared receiver in the stand-by mode
See chapter 7.2 on page 51 regarding settings.
Addr – select device address
See chapter 7.2 on page 51.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
Summary of Contents for DranTech Xtra
