- 2 -
- 3 -
1. INTRODUCTION
3. TECHNICAL
DESCRIPTION
1.1 SCOPE
This Lever Action Barrel Pump is a hand operated heavy duty pump designed to transfer oil
based fluids, heating oils, motor oils, diesel oil, kerosene, heavy & light oils
The pump comes complete with self adjusting telescopic suction tube, curved metal spout, and
1½" & 2" bung nut.
2. HEALTH AND SAFETY INFORMATION
2.1 GENERAL SAFETY INFORMATION
To ensure safe and efficient operation, it is essential to read and follow each of these warnings
and precautions.
1. Improper use or installation of this product can cause serious bodily injury or death.
2. Do NOT smoke near pump or use pump near an open flame. Fire could result.
3. When pumping flammable liquids, all equipment must be grounded to prevent the
accumulation of static electricity which may ignite vapours or gases.
4. The pump and containers should be connected using bonding clamps or clips and a
conductive wire no smaller than 12 gauge. A secure and positive metal-to-metal contact must
be made. The other end of the wire should be attached to a good ground, such as a steel
building column or water pipe.
Warning:
Leave handle in upright position when not in use.
4. ASSEMBLY
4.1 ASSEMBLY
1. Screw the suction tube assembly into the bung nut
. Tighten the connection securely to
eliminate any air leaks.
2. Screw the delivery spout nut
(part of the spout) onto the pump head. Tighten securely to
eliminate any possibility of leakage.
3. Extend the telescopic suction pipe
little longer than the height of the drum.
4. Screw the pump into the drum’s bung. Tighten the pump assembly securely by grasping the
pump body
and rotating.
5. Pull the plunger rod
of piston sub assembly up and attach the lever handle to the piston
rod using the pivot pin and retainer clip
.
Pivot Pin & retainer clip.
Plunger
rod.
Lever
handle.
Delivery
spout
Compression
nut.
Spout
nut.
Pump
head.
Rubber
grip.
Pump
body.
Bung nut.
Suction tube assembly.
3.1 IDENTIFICATION
1.2 SPECIFICATION
Stock No’s. ............................................................................................................................... 47808
Part No’s. ................................................................................................................................. BP/G
Barrel size ..................................................................................................... 1½" & 2" bung adaptor
Delivery rate ....................................................................................... up to 300ml(10oz. per stroke)
Non return seal .......................................................................................................................... NBR
Wetted components................................................................ Steel, Aluminium, Zinc, Brass & NBR.
Recommended use:
.. Oil base fluids, heating oils, motor oils, diesel oil, kerosene, heavy & light oils.
Do not use: ...............
Water based fluids, solvents, acid, antifreeze or fluids that cause corrosion.
