- 6-
OPERATION
ARMING ALARM
When leaving the protective area, point the remote
control at the sensor alarm and press the ON (alarm)
button. There will be a short beep, followed by a 30
second delay before the unit is armed. The exit delay
allows you time to leave the protected area without
activating the alarm.
DISARMING ALARM
When returning to the protected area, point the remote
control at the sensor alarm and press the OFF (alarm)
button. Note, there will be a short beep to indicate that
movement has been detected, followed by a 5 second
delay before the siren sounds. The entry delay allows you
time to enter the protected area and deactivate the alarm
before it triggers. Once the alarm is triggered, the siren
will sound for 30 seconds, then automatically reset and go
back to ARMED MODE. If movement continues, the siren
will automatically sound for a further 30 seconds, until the
sensor alarm is disarmed using the remote control.
Summary of Contents for 59319
Page 10: ... 9 NOTES ...
Page 11: ... 10 NOTES ...
