– 5 –
• operations subject to special rules (e.g. potentially
explosive atmospheres, mines, etc).
• operations that require ingress protection greater
than IPX0, e.g. in rain or snow, etc.
General:
– Training should be sought out in
• the safe use of this equipment;
• the processes;
• the emergency procedures;
– Welding power sources are not to be used for pipe
thawing.
– Take precautions against toppling over, if the power
source shall be placed on a tilted plane.
– All equipment should be kept in good working
condition, inspected and, when defective, promptly
repaired or withdrawn from service - All equipment
should be placed so that it does not present a
hazard in passageways, on ladders, or stairways,
and should be operated in accordance with the
manufacturer’s instructions.
– In the vicinity of an arc, non-reflective curtains or
screens shall be used to isolate persons from the arc
radiation. A warning, e.g. a symbol for eye
protection, should refer to the hazard of arc
radiation.
4. UNPACKING AND
CHECKING
4.1 PACKAGING
Carefully remove the product from the packaging and
examine it for any sign of damage. Check contents
against the parts shown in Fig A. If any part is damaged
or missing, please contact the Draper Help Line (see
back page). Do not attempt to use the product!
The packaging material should be retained during the
warranty period, in case the product needs to be
returned for repair.
Warning!
• Some of the packaging materials may be harmful to
children. Do not leave any of these materials in reach
of children.
• If any of the packaging is to be thrown away, make
sure they are disposed of correctly, according to local
regulations.
