Draper MIG100GG, Instructions Manual

10

5.  HEALTH & SAFETY INFORMATION

–  Welding power sources are not 

to be used for pipe thawing.

–  Take precautions against 

toppling over, if the power 
source shall be placed on a tilted 
plane.

–  All equipment should be kept in 

good working condition, 
inspected and, when defective, 
promptly repaired or withdrawn 
from service - All equipment 
should be placed so that it does 
not present a hazard in 
passageways, on ladders or stairways, and should be operated in accordance with the 
manufacturer's instructions. 

–  In the vicinity of an arc, non-reflective curtains or screens shall be used to isolate persons 

from the arc radiation. A warning, e.g. a symbol for eye protection, should refer to the 
hazard of arc radiation.

5.3 CONNECTION TO THE POWER SUPPLY

Caution:

 Risk of electric shock. Do not open.

Make sure the power supply information on the machine’s rating plate is compatible with 
the power supply you intend to connect it to. 

This product comes supplied with a UK standard 3 pin plug fitted. It is designed for 
connection to a domestic power supply rated at 230V AC. 

Because it is constructed mostly of metal parts, it is a Class 1 machine; meaning, it must have 
an earth connection in the power supply. This is to prevent electrocution in the event of a 
failure.

Apart from replacing the fuse in the plug, no other electrical work is recommended on this 
product.

S

H

NO

1~

1~

IEC 60974-1

21A/15V – 100A/19V

X%

10%

100%

I

2

I

1max

  13A

U

1

 230V

IP 21S

1~50/60Hz

U

0

 18.5V

30V

I

1eff

  6A

100

32

V

2

19

15.5