Draper MIG100GG, Instructions Manual

5.  HEALTH & SAFETY INFORMATION

5.1 GENERAL SAFETY INSTRUCTIONS FOR POWER TOOL USE

When using any type of power tool there are steps that should be taken to make sure that 
you, as the user, remain safe.

Common sense and a respect for the tool will help reduce the risk of injury.
Read the instruction manual fully. Do not attempt any operation until you have read and 
understood this manual.
Most important you must know how to safely start and stop this machine, especially in an 
emergency.

Keep the work area tidy and clean.

 Attempting to clear clutter from around the machine 

during use will reduce your concentration. Mess on the floor creates a trip hazard. Any liquid 
spilt on the floor could result in you slipping.

Find a suitable location.

 If the machine is bench mounted; the location should provide good 

natural light or artificial lighting as a replacement. Avoid damp and dust locations as it will 
have a negative effect on the machine’s performance. If the machine is portable; do not 
expose the tool to rain. In all cases do not operate power tools near any flammable 
materials.

Beware of electric shock.

 Avoid contact with earthed surfaces; because they can conduct 

electricity if there is an electrical fault with the power tool. Always protect the power cable 
and route it away from danger.

Keep bystanders away.

 Children, onlookers and passers by must be restricted from entering 

the work area for their own protection. The barrier must extend a suitable distance from the 
tool user.

Unplug and house all power tools that are not in use.

 A power tool should never be left 

unattended while connected to the power supply. They must be housed in a suitable 
location, away locked up and from children.

Do not overload or misuse the tool. 

All tools are designed for a purpose and are limited to 

what they are capable of doing. Do not attempt to use a power tool (or adapt it in any way) 
for an application it is not designed for. Select a tool appropriate for the size of the job. 
Overloading a tool will result in tool failure and user injury: This covers the use of accessories.

Dress properly.

 Loose clothing, long hair and jewellery are all dangerous because they can 

become entangled in moving machinery: This can also result in parts of body being pulled 
into the machine. Clothing should be close fitted, with any long hair tired back and jewellery 
and neck ties removed. Footwear must be fully enclosed and have a nonslip sole.

Wear personal protective equipment (PPE). 

Dust, noise, vibration and swarf can all be 

dangerous if not suitably protected against. If the work involving the power tool creates dust 
or fumes; wear a dust mask. Vibration to the hand, caused by operating some tools for 
longer periods must be protected against. Wear vibration reducing gloves and allow long 
breaks between uses. Protect against dust and swarf by wearing approved safety goggles or 
a face shield. These are some of the more common hazards and preventions; however, always 
find out what hazards are associated with the machine/work process and wear the most 
suitable protective equipment available.

Do not breathe contaminated air.

 If the work creates dust or fumes; connect the machine (if 

possible) to an extraction system either locally or remotely. Working outdoors can also help if 
possible.

Move the machine as instructed.

 If the machine is hand held, do not carry it by the power 

supply cable. If the product is heavy; employ a second or third person to help move it safely 
or use a mechanical device. Always refer to the instructions for the correct method.

6