background image

Installation Instructions 

PART NUMBERS: 24943, 77330, CQT24943 

Applications: 

 Years 

   Make 

 Models 

2016-Current*     Chevrolet 

 Cruze 

 Equipment Required: 

Ratchet 

Torque 

Wrench 

Safety 

Glasses 

Sockets 

 7 mm 
15 mm 

DO NOT EXCEED LOWER OF TOWING VEHICLE 

MANUFACTURER’S RATING OR: 

Hitch Type 

Max Gross Trailer Weight 

Max Tongue Weight 

Weight Carrying 

2000 lb. (908 kg) 

200 lb. (90.8 kg) 

Weight Distributing 

N/A 

N/A 

Representative Vehicle Photo 

Installation Time: 

 80 min

 

The time listed above is the average time 
for professional installers. If you do not 
feel comfortable performing this 
installation on your own or are in need of 
assistance, please contact a professional 
installer.  

Trailer Hitch

 Illustration 

Front of 

Vehicle 

6’’ Socket 
Extension 

Star 

Driver 

T15 

Utility 

Knife 

Marker 

Summary of Contents for 24943

Page 1: ...ross Trailer Weight Max Tongue Weight Weight Carrying 2000 lb 908 kg 200 lb 90 8 kg Weight Distributing N A N A Representative Vehicle Photo Installation Time 80 min The time listed above is the average time for professional installers If you do not feel comfortable performing this installation on your own or are in need of assistance please contact a professional installer Trailer Hitch Illustrat...

Page 2: ...ved in Step 1 Note check hitch frequently making sure all fasteners and ball are properly tightened If hitch is removed plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes A hitch or ball which has been damaged should be removed and replaced Observe safety precautions when working beneath a vehicle and wear eye protection Do not cut access or attachment hol...

Page 3: ...tly remove the fascia Carefully set the bumper fascia aside 2 Bumper beam removal use 15mm socket to remove 3 flange nuts from bumper plate each side Gently remove bumper beam and set it aside 3 Hitch installation raise the hitch and hang it on the studs on the end panel Raise the bumper beam to sandwich the hitch see Figure 1 Reuse the bumper flange nuts and loosely fasten them ...

Page 4: ...t 72 N M 5 Bottom fascia trimming locate the center of bottom panel and trim 4 5 tall by 3 5 wide area see Figure 3 6 Reinstall all fasteners and fascia removed in Step 1 Proper torque is needed to keep the hitch secure to the vehicle when towing 4 5 3 5 ...

Reviews: