ADJUSTMENT OF BELT-TENSION _
(1) Run the treadmill belt up to 5km/h for approximately 1 minute, watch the belt alignment at the
rear roller. The belt should sit in the middle of the rear roller.
(2) If the belt is tracking closer to the right hand side of the machine use an 8mm Allen key wrench and
tighten the right hand side roller adjustment bolt (see pic below) by ¼ of a turn in the clockwise direction.
Then monitor the belt running for another minute. Keep repeating this procedure until the belt is
centered on the rear roller.
(3) If the belt is tracking closer to the left hand side of the machine use an 8mm Allen key wrench and
tighten the left hand side roller adjustment bolt (see pic below) by ¼ of a turn in the clockwise direction.
Then monitor the belt running for another minute. Keep repeating this procedure until the belt is
centered on the rear roller.
(4) If the belt is running in the centre of the roller but slipping under the foot when walking simply tighten
both right and left hand roller adjustment bolts ¼ of a turn in the clockwise direction. Repeat this
procedure until the belt stops slipping. If slipping continues please contact customer support.
NOTE : To access the roller adjustment bolts you will have to slide the Allen key wrench through
the access hole in the end caps (see picture below).
7
NOTE :
Do not over tension the running belt.
If the belt continues to slip after multiple
attempts to tension it, please contact
DRAX INC.
Customer Support Center.
Adjustment of
Belt-Tension
