VigorPro 5510 Quick Start Guide
7
2
2
.
.
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
Y
Y
o
o
u
u
r
r
V
V
i
i
g
g
o
o
r
r
R
R
o
o
u
u
t
t
e
e
r
r
2
2
.
.
1
1
H
H
a
a
r
r
d
d
w
w
a
a
r
r
e
e
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
This section will guide you to install the router through hardware connection and configure the
router’s settings through web browser.
Before starting to configure the router, you have to connect your devices correctly.
1.
Connect a cable Modem/DSL Modem/Media Converter (depends on your requirement) to
any WAN port of router with Ethernet cable (RJ-45). The
WAN1/WAN2
LED (Left or
Right) will light up according to the speed (100 or 10) of the device that it connected.
2.
Connect one end of an Ethernet cable (RJ-45) to one of the
LAN
ports of the router and the
other end of the cable (RJ-45) into the Ethernet port on your computer. The
LAN
LED (Left
or Right) will light up according to the speed (100 or 10) of the device that it connected.
3.
Connect the printer to the router with the USB cable if required.
4.
Connect one end of the power adapter to the router’s power port on the rear panel, and the
other side into a wall outlet.
5.
Power on the device by pressing down the power switch on the rear panel.
6.
The system starts to initiate. After completing the system test, the
ACT
LED will light up
and start blinking.
(For the detailed information of LED status, please refer to section 1.1.)
