Vigor2710 Series User’s Guide
10
1
1
.
.
3
3
H
H
a
a
r
r
d
d
w
w
a
a
r
r
e
e
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
Before starting to configure the router, you have to connect your devices correctly.
1.
Connect the ADSL interface to the external ADSL splitter with an ADSL line cable for
all models. For Vigor2710Vn/VDn, also connect Line interface to external ADSL
splitter.
2.
Connect one end of an Ethernet cable (RJ-45) to one of the
LAN
ports of the router and
the other end of the cable (RJ-45) into the Ethernet port on your computer.
3.
Connect the telephone sets with phone lines (for using VoIP function). For the model
without phone ports, skip this step.
4.
Connect one end of the power adapter to the router’s power port on the rear panel, and
the other side into a wall outlet.
5.
Power on the device by pressing down the power switch on the rear panel.
6.
The system starts to initiate. After completing the system test, the
ACT
LED will light
up and start blinking.
Here, we take
Annex A
model as an example for describing hardware installation.
Summary of Contents for Vigor2710 Series
