Vigor2910 Series User’s Guide
125
Profile Name
Specify a name for the profile of the LAN to LAN connection.
Enable this profile
Check here to activate this profile.
VPN Connection Through
Use the drop down menu to choose a proper WAN interface
for this profile. This setting is useful for dial-out only.
WAN1 First
- While connecting, the router will use WAN1
as the first channel for VPN connection. If WAN1 fails, the
router will use another WAN interface instead.
WAN1 Only
- While connecting, the router will use WAN1
as the only channel for VPN connection.
WAN2 First
- While connecting, the router will use WAN2
as the first channel for VPN connection. If WAN2 fails, the
router will use another WAN interface instead.
WAN2 Only
- While connecting, the router will use WAN2
as the only channel for VPN connection.
Netbios Naming Packet
Pass
– click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel while
connecting.
Block
– When there is conflict occurred between the hosts on
both sides of VPN Tunnel in connecting, such function can
block data transmission of Netbios Naming Packet inside the
tunnel.
Multicast via VPN
Some programs might send multicast packets via VPN
connection.
Pass
– Click this button to let multicast packets pass through
the router.
Block
– This is default setting. Click this button to let
multicast packets be blocked by the router.4
Call Direction
Specify the allowed call direction of this LAN to LAN profile.
Both
:-initiator/responder
Dial-Out
- initiator only
Dial-In-
responder only.
Always On or Idle Timeout Always On-
Check to enable router always keep VPN
connection.
Idle Timeout:
The default value is 300 seconds. If the
connection has been idled over the value, the router will drop
the connection.
Enable PING to keep alive
This function is to help the router to determine the status of
IPSec VPN connection, especially useful in the case of
abnormal VPN IPSec tunnel disruption. For details, please
refer to the note below. Check to enable the transmission of
PING packets to a specified IP address.
PING to the IP
Enter the IP address of the remote host that located at the
other-end of the VPN tunnel.
Enable PING to Keep Alive
is used to handle abnormal
IPSec VPN connection disruption. It will help to provide
Summary of Contents for Vigor2910 Series
