Vigor3300 Series User’s Guide
15
IP Mode
Select an IP mode for this WAN interface. There are four available
modes for Internet access,
Static
,
DHCP
,
PPPoE,
and
PPTP
. On
this page you may configure the WAN interface to use
Static
(fixed
IP),
DHCP
(dynamic IP address),
PPPoE
or
PPTP
. Most of the
cable users will use the
DHCP
mode to get a globally reachable IP
address from the cable host system.
2
2
.
.
2
2
.
.
1
1
S
S
t
t
a
a
t
t
i
i
c
c
M
M
o
o
d
d
e
e
You can manually assign a static IP address to the WAN interface and complete the
configuration by applying the settings and rebooting your router. Choosing
Static
as the IP
mode, you will see the following page:
All the settings here are set by privately. Your ISP will not provide these settings.
IP Address
Assign a private IP address to the WAN interface.
Subnet Mask
Assign a subnet mask value to the WAN interface.
Default Gateway
Assign a private IP address to the gateway.
Primary DNS
Assign a private IP address to the primary DNS.
Secondary DNS
Assign a private IP address to the secondary DNS.
IP Alias List
Assign other IP addresses to be bound to this interface. This
setting is optional. If you have typed addresses here, you can
see and choose it in later web page settings (e.g.,
Advanced >>
NAT>>Port Redirection/DMZ Host
).
Thirty-two IP addresses
settings are allowed at one time.
After setting up the
WAN
interface, the user can click
Next
to setup the LAN interface
continuously.
Summary of Contents for Vigor3300 Series
Page 1: ......
Page 152: ...Vigor3300 Series User s Guide 146 This page is left blank ...
