Vigor3300 Series User’s Guide
40
Default MAC
Uses the default Mac address.
User Defined MAC
Uses a MAC address defined by users. If you select this item, you
have to type the MAC address in the box below.
Downstream Rate
Set downstream rate for this WAN interface. The default value is
102400 kbps (100 Megabit).
Upstream Rate
Set transmission rate for this WAN interface. The default value is
102400 kbps (100 Megabit).
Type
Set connection type for this WAN interface.
Physical Mode
Set connection speed mode. There are five options including
Auto
negotiation
,
full duplex
,
half duplex,
10M
and
100M
.
IP Mode
Set an IP Mode with
Static (fixed IP)
,
DHCP (dynamic IP
address),
PPPoE,
PPTP
or
DMZ
and creates the IP group
information. Most cable modem users will use DHCP to get a
globally reachable IP address from the cable head-end system.
Different mode will lead different configuration and will be
explained in later section.
Before you connect a broadband access device e.g. a DSL/Cable modem to Vigor3300 Series,
you need to know what kind of Internet access your ISP provides. The following sections
introduce four widely used broadband access services:
Static, PPPoE
,
PPTP
for DSL,
DHCP
for Cable modem and
DMZ
. In most cases, you will get a DSL or cable modem from the
broadband access service provider. Vigor3300 Series is connected behind the broadband
device i.e. DSL/cable modem and works as a NAT or IP router for broadband connections.
Next, we will introduce each WAN mode in detailed.
S
S
t
t
a
a
t
t
i
i
c
c
I
I
P
P
S
S
e
e
t
t
u
u
p
p
It means that the IP group information for WAN interface is manually assigned by the user.
Summary of Contents for Vigor3300 Series
Page 1: ......
Page 152: ...Vigor3300 Series User s Guide 146 This page is left blank ...
