VigorPro5300 Series User’s Guide
33
For static IP mode, you usually receive a fixed public IP address or a public subnet, namely
multiple public IP addresses from your DSL or Cable ISP service providers. In most cases, a
Cable service provider will offer a fixed public IP, while a DSL service provider will offer a
public subnet. If you have a public subnet, you could assign an IP address or many IP
address to the WAN interface.
To use
Static or Dynamic IP
as the accessing protocol of the internet, please choose
Internet Access
from
WAN
menu. Then, select
Static or Dynamic IP
mode for WAN2.
The following web page will be shown.
Static or Dynamic IP
(DHCP Client)
Click
Enable
for activating this function. If you click
Disable
,
this function will be closed and all the settings that you adjusted
in this page will be invalid.
ISDN Dial Backup
Setup
This setting is available for the routers supporting ISDN function
only. Before utilizing the ISDN dial backup feature, you must
create a dial backup profile first.
None
- Disable the backup function.
Packet Trigger -
The backup line is not on until a packet from a
local host triggers the router to establish a connection.
This setting is available for
i
model only.
Keep WAN
Connection
Normally, this function is designed for Dynamic IP environments
because some ISPs will drop connections if there is no traffic
within certain periods of time. Check
Enable PING to keep alive
box to activate this function.
PING to the IP
- If you enable the PING function, please specify
the IP address for the system to PING it for keeping alive.
Summary of Contents for VigorPro 5300
