VigorPro5300 Series User’s Guide
47
2.
After checking the box to enable VLAN function, you will check the table according to
the needs as shown below.
To remove VLAN, uncheck the needed box and click
OK
to save the results.
3
3
.
.
2
2
.
.
5
5
B
B
i
i
n
n
d
d
I
I
P
P
t
t
o
o
M
M
A
A
C
C
This function is used to bind the IP and MAC address in LAN to have a strengthen control in
network. When this function is enabled, all the assigned IP and MAC address binding
together cannot be changed. If you modified the binding IP or MAC address, it might cause
you not access into the Internet.
Click
LAN
and click
Bind IP to MAC
to open the setup page.
Enable
Click this radio button to invoke this function.
However, IP/MAC
which is not listed in IP Bind List also can connect to Internet.
Disable
Click this radio button to disable this function. All the settings on
this page will be invalid.
Strict Bind
Click this radio button to block the connection of the IP/MAC
which is not listed in IP Bind List.
ARP Table
This table is the LAN ARP table of this router. The information
for IP and MAC will be displayed in this field. Each pair of IP
Summary of Contents for VigorPro 5300
