DrBrowns Natural Flow Insta-Feed AC185-INTL, Instructions For Use Manual

3

WARMING BOTTLES AND FOOD JARS 

Always unplug the warmer before filling.
1.  Remove the Measuring Cup from the rear of the warmer.
2.  Add 

DISTILLED

 water to the Measuring Cup, following 

the Warming Guide on page 5 to determine the 
amount of water to add based on your bottle type. 

NOTE: These amounts are a guide only. There 

are many variables that can impact the final 

temperature of the bottle or food jar you are 

warming, such as starting temperature, size, and 

shape. Always test the temperature before feeding 

your baby. 

3.  Pour the 

DISTILLED

 water from the Measuring Cup directly into the Warming 

Chamber. Do not overfill, as overfilling may cause the bottle/food jar to be overheated 
or may cause damage to the unit.

4.  Replace the Measuring Cup and plug in the power cord. 

NOTE: The first time the unit is plugged in, the warming cycle may begin 

automatically. If the Indicator Light is on upon plugging unit in, wait for the 

warming cycle to end (Indicator Light will turn off) and allow the unit to cool 

down for 10 minutes before using. 

5.  Place the bottle or food jar inside the Warming Chamber as outlined below.

•  Wide Neck Bottle:

 Place bottle directly into Warming Chamber.

•  Narrow Bottle: 

Place Adapter Ring on top of Warming Chamber, then 

place bottle in Warming Chamber. The Adapter Ring will keep your bottle 
centered over the heating plate for even warming.  

NOTE: To prevent leakage when warming Dr. Brown’s® 

bottles, remove the internal parts, collar, and nipple/teat, 

and replace with the included Storage Cap.

•  Food Jar: 

Place food jar into the Lift-Out Basket, then place 

Lift-Out Basket in Warming Chamber. 

NOTE: Always remove the lid of the food jar prior to warming. After 

warming cycle is complete, be sure to stir food thoroughly until it is 

an even temperature throughout.

6.  Press the Power Button. The Indicator Light will turn on, indicating the warming 

cycle has begun. 

CAUTION:

 Always add water and then press Power Button. If the Power 

Button is pressed first, steam may form when water is added.  

NOTE: If the Power Button is pressed without water added, the unit will shut 

off automatically after a short period. If this happens, wait at least 10 minutes 

to allow warmer to cool before adding water and starting warming cycle.

7.  When the Indicator Light turns off, the warming cycle is done. Remove the 

bottle/food jar promptly to avoid overheating. 

NOTE: Always test the temperature before feeding your baby. Adjust the 

amount of water added to the warming chamber as needed; if the bottle/

food jar is too cold, add slightly more water next time. If the bottle/food jar 

is too warm, use slightly less water next time.

8.  Wait at least 10 minutes to allow warmer to cool before using again. 

USE DISTILLED 

WATER ONLY!

Tap water and bottled 

water contain minerals 

that shorten the life of this 

appliance. Damage from 

use of non-distilled water 

will void the warranty.