ASSEMBLY
A er cleaning, follow these steps to assemble your Collection Units:
Make sure the Breastcup is sealed all
around. This is important for the pump
to function properly.
Note:
Run your fi ngers and thumbs around
the edge to make sure the Breastcup is affi
xed
all around.
l
Begin by placing the Bo le Seal into
the bo om of the Connector.
Then secure the Collection Bo le to the
Connector. Tightening the Collection Bo le
fi rmly will seal the Bo le Seal, but do not
over tighten.
To install the Breastcup, insert into the
Connector and then push at the edges
to secure the Breastcup to the Connector.
l
l
l
CLEANING
Before your fi rst use and a er all other
uses, it is important to wash your
Breast Pump:
Make sure all Collection Unit parts have
been disassembled for cleaning prior to
use. Do not wash the
AC Power Cord.
For
Motor Unit,
wipe clean with dry or
damp cloth as necessary.
For
Air Tubing,
wipe
exterior clean with
dry or damp cloth as necessary. Do not
get interior of Air Tubing wet. Do not
submerge Air Tubing in water. Do not
sterilize Air Tubing.
For Collection Unit parts:
TOHANDWASH
Wash all parts in warm,
soapy water, rinse well and air dry.
INDISHWASHER
All pump parts are
top-rack dishwasher safe. Completely air
dry parts and let them cool.
The
Breastcup
and
Sealing Insert
are
delicate parts. Please take extra care in
cleaning them. It is recommended that
you hand wash these parts. Do not use
any rough brushes to clean these parts.
Summary of Contents for S1006
Page 1: ......
