RADIO GEAR SETUP
►
The following setup is based on the use of our sturdy 12.4g DMG (Digital Metal Gear) servos (
Part DFFA009
).
We have included the exact measurements needed to recreate our setup if you choose another type of servo;
however, don't skimp on servos for your Weasel-TREK! A durable, high quality digital servo with excellent
centering will ensure that your Weasel-TREK is a smooth, predictable flyer.
Gather items below:
Transmitter (battery fully charged)
Micro receiver
(2) Servos with servo arms and screws
(Part DFFA009)
Battery Extension Wire (
Part DFFA013)
4.8V, 750mAh receiver battery (fully charged)
(Part DFFA012)
1.
Locate servo arms with four holes on each arm.
Place small servo screws in a safe place.
2.
Plug Battery Extension Wire into receiver (observe
proper polarity!). This extension wire replaces a
switch and makes it easier to turn on the glider
and charge the battery.
3.
Turn on transmitter and plug battery into female
end of Battery Extension Wire to power up
receiver.
4.
Activate transmitter's Elevon mixing function
(consult your radio manual for details). Elevon
mixing may be referred to as "Delta" mixing on
some transmitter models.
5.
Connect servos to appropriate receiver channels.
Confirm system is bound and servos are
responding smoothly.
6.
Ensure all Trims and Sub-Trims are set to zero, and
all End Points and/or Adjustable Throw Volumes
(ATV) are set to the default of 100%.
3.
Summary of Contents for r2106gf
Page 1: ......
Page 5: ......
Page 27: ...SLOPE SOARING FUNDAMENTALS Views from side and above 20...