Dream Maker Spas ECLIPSE, Owner'S Manual

5

CAUTION:

Drain waste water may contain chemical residue and unsanitary contaminants which
could be a hazard to health or the environment. Drain to specified sanitary sewer only.

WARNING: DO NOT SUPPLY POWER TO AN EMPTY SPA!

LOCATION OF ELECTRICAL CORD & DRAIN 

FOR

X-SPA

AND

X-CAL SERIES

The spa equipment requires a 15 amp outlet, dedicated to the spa. 

The use of any extension cord will void your warranty.

Carefully read all of the safety requirements before plugging in the spa.

EACH TIME BEFORE FILLING THE SPA

1. Open access panel. (see picture #1)

2. Pull out the drain pipe. (see picture #6)

3. Check to be sure that the shut off valve is closed (handle

perpendicular to the drain pipe).

4. Safety cap is securely in place.

The spa drain valve assembly consists of a
flexible drain pipe, shut off valve and safety
drain cap and is located in the equipment
compartment.

Route G.F.C.I. power cord underneath the spa
through the cord channel molded in the front
bottom access corner hole. See next picture.

G.F.C.I. power cord routed through front left
corner access hole. For illustration purposes,
in this photo the cord has not been fully pulled
out. In all actual installations, the power cord
should be fully pulled out to facilitate clearances
from hazards.

TO DRAIN THE SPA

1. Unplug the electrical power cord. Do not supply electrical

power again until spa is refilled.

2. Open access panel. (see picture #1)

3. Pull out the drain pipe.

4. Remove safety cap.

5. Attach a standard garden hose to the threaded safety

cap nipple.

6. Place the other end of the garden hose in a drain area.

7. Open the shut off valve and monitor the draining.

Remove and save access panel screws. Use
caution when reinstalling the screws. Do not
overtighten.

Open access panel.

Find power cord with G.F.C.I. and inspect the
full length of the cord for any damage before
each use.

1

2

3

4

5

6