6.0 MENU AND PICTURE SETTING
R699800 - Inti Series User Manual
31
6.2.0.2
Detail Enhancement
Detail Enhancement function is used to improve the picture details to make them
stand out. between 0 (soft) and 50 (strong).
6.2.0.3
Noise Reduction (SD video only)
RNR: Random Noise Reduction. You can set it from 0 up to 16 to reduce the image
random noise.
MNR: Mosquito Noise Reduction function is used to reduce the Mosquito noise on
the picture, generally found in compressed digital video signals such as television
broadcast or encoded movies. Adjust the MNR value from 0 up to 16 to reduce the
typical broadcast picture mosquito noise
BNR: Block Noise Reduction uses a large portion of the picture to reduce the digital
noise, this ensures a higher quality filter. Adjust the BNR value to On or Off.
6.2.0.4
CTI (SD video only)
Color Transition Improvement. Set it to Off, Low, Middle or High to reduce the color
smear (color contour correction). Caution: this function may alter the original picture
chrominance.
6.2.0.5
Color Space (Inti One only)
Standard: Digital Cinema Initiatives (DCI) color space.
Wide1: wider color gamut than standard. Color space used for HDTV.
Wde2: same color space as DCI but within a wider color gamut
6.2.0.6
Color Management (TSL adjustments) (Inti 2 & Inti 3)
The Color Management gives the installer an unique calibration ease with the
integrated Color Adjustment menu: each primary, secondary colors and orange can
be independently calibrated to obtain a precise color balance in a snap.
Adjust the Red, Green, Blue, Yellow, Cyan, Magenta and Orange Tints, Saturations
and Luminances and store them into Custom1, Custom2 or Custom3 profiles.
6.2.0.7
Crystal Motion Drive (120Hz)
The Crystal Motion function uses a 120Hz video processing to render a smooth and
clear motion for movies shot at 24Hz or HD movies at 60Hz. Set the correct level
between:
Mode1: weak black frame insertion
Mode2: strong black frame insertion
Mode3: weak interpolation
Mode4: strong interpolation
Film Motion: inverse telecine interpolation
Additionally, you can set the Clear Motion Demo side-by-side or top-and-bottom.
6.2.0.8
Lens Aperture
The lens is equipped with a variable electronic aperture. This function is used to
optically adjust the light output depending on the viewing conditions and the light
ambiance. Adjust from the correct aperture from partially closed to fully opened.
6.2.0.9
Lamp Power (Inti 2 & Inti 3)
Set the lamp power used by the current Picture Profile:
Normal: lamp is set to 160W
High: lamp is set to 220W.
To avoid any damage to the lamp, you can’t changed the lamp power within 90
seconds from the projector startup or 60 seconds after lamp power change.
Reset
Reset the current Picture Profile to default settings.
6.3
Input Signal menu
HDMI Inputs
This menu is available if the selected active input is HDMI1 or HDMI2.
Summary of Contents for Inti R699800 series
Page 1: ......
Page 54: ...9 0 MISCELLANEOUS 54 R699800 Inti Series User Manual ...
Page 55: ......
Page 56: ......
