© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
ENIGMA AIR ENCLOSURE Shower Enclosure manual Ver 1 Rev 4 062019
30
©2019 DreamLine. All Rights Reserved
!
!
!
1
2
3
4
5
6
8
7
Panel side
Panel side
Panel side
Panel side
Door side
Door side
Door side
Door side
*
Stopper Locations as measured from the wall to the center of the stopper:
• Panel side: 5” (+/- 1/16“) where the door makes contact with the bottom bumper
• Door side: 3-1/2” (+/-) (depends on opening conditions)
!
***Position the Panel-side stopper so that the door glass
makes contact with the stopper and bottom bumper at
the same time.
NOTE:
Cover the shower/tub drain with tape prior to removing the set screws to prevent loss.
Fig 36a
Fig 36b
36.
Position the
Stoppers (#05)
,
remove the set screws from the
Stoppers (#05)
and apply
Thread Lock Adhesive (#20)
to the
threads. Reinsert the set screws into the
Stoppers (#05).
Correctly position the
Stoppers (#05)
and s
crew them tightly to
the
Guide Rail (#04)
with the supplied allen wrench
.
NOTE:
The
Stoppers (#05)
must be positioned
correctly to prevent the handle from contacting the
Stationary Glass (#02)
and to stop the
Door Glass
(#03)
in a position that allows the bumper strip to
create a seal with the wall, but does not allow the
door glass to bang into the wall during normal
operation.
(Fig
36a and 36b)
Stopper
Thread Lock Adhesive
Door Stopper Installation:
1. Remove the set screws
2. Slide the
Door
open until it makes contact with the bottom
SafeStop™
Bumper (#26)
to correctly
position the panel side
Stopper (#05)
on the
Upper Guide Rail (#04).
3. Remove the set screw threads and apply
Thread Lock Adhesive (#20)
4. Reinsert the set screws into the
Stopper (#05)
and fully tighten.
(Fig 36b)
5. Repeat on the Door side and position the
Stopper (#05)
so that the bulb vinyl seals with the wall.
