© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
NOTE: To maximize the life of your door, it is important to regularly inspect
the glass and other hardware for misalignment, proper attachment, and/or
damage. Contact DreamLine
®
with any questions or concerns.
Product Maintenance
BASES and BACKWALLS:
To ensure long lasting life for your acrylic back walls: wipe them off
after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream
based cleaners. Avoid the use of aerosol spray cleaners. Never use abrasive cleansers, metal
brushes or scrapers that could scratch or dull the surface.
GLASS:
To ensure long lasting life for your glass shower products: wipe them off after each use
with a soft cloth. Rinse and wipe off the glass using either a soft cloth or a squeegee to prevent
soap buildup and water spots (Hard water can etch the surface of the glass over time if left to
dry). To prevent scratching the surface: never use abrasive cleaners or cleaning products that
contain scouring agents. Never use bristle brushes or abrasive sponges that may scratch the
surface.
HARDWARE:
To ensure a long lasting finish: wipe off the metal parts after each use with a soft
cloth. Do not use abrasive cleaners or cleaning products containing ammonia, bleach or acid. If
accidentally used, rinse the surface as soon as possible to prevent damage to the finish (peeling
or corrosion). After cleaning the polished finishes, rinse thoroughly and wipe dry with soft cloth.
Clean stainless steel surfaces at least once a week. When applying stainless steel cleaner or
polish to stainless steel hardware, work with (not across) the grain. Never use an abrasive
sponge or cloth, steel wool or wired brush as these may permanently scratch the surfaces.
Enigma-Air Enclosure Maintenance Checklist
◻
Guide rail
level and tight
◻
Guide rail brackets
tight to the walls
o All set screws tight
◻
Inline
and
Return Panel glass
secure
◻
Panel glass brackets
tight
◻
Guide block
square to the threshold and glass
◻
Proper clearance beneath the door glass between the threshold and within the guide block
◻
Door Glass
adjusted so that the
Bulb vinyl seal
makes even contact with the return panel glass
◻
Wheel assemblies
tight
o Wheel
roller bolts
tight
◻
Stoppers
tight and positioned correctly
o
Panel-side stopper
tight and secured to the guide rail
o Adequate
Handle clearance
when the door is fully open
o
Door-side stopper
positioned at approximately 4” (+/- 1/8”) (as measured from the
return panel glass to the center of the stopper)
◻
Stopper
stops the door and bulb vinyl seals to the return panel glass
◻
SafeStop bumper
secure to the wall
◻
Roller guards
positioned within 1/16” beneath guide rail
◻
Remove vinyl seals to
inspect the edges of the door glass
for concealed damage
o
Damaged glass must be replaced!
◻
Replace damaged or missing vinyl seals
ENIGMA AIR ENCLOSURE Shower Enclosure manual Ver 1 Rev 4 062019
32
©2019 DreamLine. All Rights Reserved
