©2017 DreamLine. All Rights Reserved
13
ENIGMA Z Enclosure Manual Ver 1 Rev 4 04/2017
Fig. 7
Fig. 8
W
W
door end
door end
glass bracket
holes
8.
The Upper Guide Rail (#03) has been precut
for your model width of: 48” or 60”
(the actual rail is shorter than the model width
by design).
Cut the Upper Guide Rail (#03) from the door
end only, which is the end that is farther from
the Glass Bracket (#07) holes. (Fig. 8)
The length to cut off will be L:
Model Width – opening W = cut off length L
7.
Measure the distance from the finished wall to
the inside surface of the installed Return Panel
Glass (#22).
This distance will represent the finished opening size
“W” that will be used to calculate the finished cut
dimension for the Upper Guide Rail (#03). (Fig. 7)
FOR EXAMPLE:
If the model width is 60” and the finished
opening from the finished wall to the inside
surface of the installed Return Panel Glass (#22)
is 58”, then you will need to cut 2” off of the rail:
Example: 60” – 58” = 2” cut off length
*Note that this is only an example and the
actual cut-off length will vary based on the
actual finished opening dimension.