©2017 DreamLine. All Rights Reserved
15
ENIGMA Z Enclosure Manual Ver 1 Rev 4 04/2017
1
2
3
Fig. 11
Fig. 12
Glass Connector (#21)
not used in this
configuration
X
sleeve
Lower guide rail
Raise guide rail
Glass Bracket adjustments
10.
Place the Stationary Glass (#02) with the Upper Guide
Rail (#03) onto the threshold and position it against the wall.
Fasten the Upper Guide Rail (#03) to the Return Panel Glass
(#22) using the Glass Connector (#21).
Tighten the set screws to secure the guide rail bracket sleeve to
the Glass Connector (#21). (Fig. 11)
11.
Make sure the Stationary Glass (#02) is plumb and the Guide Rail (#03) is level. Adjust the
Guide Rail (#03) to level by using the Glass Connector (#21) and Glass Brackets (#07). If necessary,
rotate the elliptical adjustment disk on the outside of the Glass Bracket (#07), and then re-tighten the
bolt while holding the adjustment disk in place.
Dry fit the Guide Block (#12) into the notch of the Stationary Glass (#02) and mark its position on
the threshold. (Fig. 12)