©2017 DreamLine. All Rights Reserved
18
ENIGMA Z Enclosure Manual Ver 1 Rev 4 04/2017
protective
padding
protective
padding
3
1
2
1
2
3
4
Fig. 17
Fig. 18
Painter’s Tape
!
NOTE: Before you install the Stationary Glass (#02),
bring the Door Glass (#05) into the shower and lean it
against the wall. Make sure the door is facing in the right
direction for installation with the handle holes on the correct side.
After the Stationary Glass (#02) is installed, it may not be
possible to easily get the door glass into the shower or to turn it
around. Always use padding to protect the door glass and
shower surfaces.
NOTE: Do Not attach the handle to the door glass until
instructed.
Do Not attempt to lift the door glass with the handle as this
may result in damage to the glass and/or serious personal
injury. Use a professional grade glass suction cup and an
assistant.
17.
Apply silicone to the bottom of the Anti-Splash Guard (#15) and the Guide Block (#12). Insert
one end of the Anti-Splash Guard (#15) fully into the Guide Block (#12) and align both pieces on
the threshold using the marks made in
Step #13
.
16.
Fasten the Wall Bracket (#19) to the wall using the Truss Head Screw ST4.2×55 (#18). (Fig. 17.1)
Mount the base
part of
the Guide Rail Bracket (#08)
to
the wall using the
Large Truss Head Screw
ST6×65
(#10).
Note that the adjustment Set Screws on the bracket must be aligned vertically for
easier access to adjust for level after the glass is installed. (
Fig. 17)
Fasten the Upper Guide Rail (#03) to the Return Panel Glass (#22), connecting the sleeve of the Guide
Rail Bracket (#08) to the Glass Connector (#28) (Fig. 17.3 and Fig. 17.4) on the return panel glass. Align
the set screws vertically and tighten. (Fig. 17)
Apply silicone to the
Anti-Splash Guard Cap (#16),
and place it at the wall end of
the Anti-Splash Guard (#15).
Apply several strips of painter’s
tape to hold the Anti-Splash
Guard (#15) and Cap in place
while the silicone cures.
(Fig. 18)