©2017 DreamLine. All Rights Reserved
20
ENIGMA Z Enclosure Manual Ver 1 Rev 4 04/2017
TIP: Level the installed Upper Guide Rail (#03) as necessary using the Guide Rail Brackets (#08) first
and then the Glass Brackets (#07).
Start adjustments from the door end. (Fig. 22 and Fig. 23)
1
2
3
Fig. 23
Fig. 22
Fig. 21
Ø1/8"
Panel end
Door end
Glass bracket
Guide Rail Bracket
or Glass Connector
(Right hand door installation shown as example)
To lower the rail using the
Guide Rail Bracket:
Loosen the top set screw and
tighten the bottom set screw.
To raise the rail:
Loosen the bottom set screw
and tighten the top set screw.
To raise or lower the rail
using the Glass Connector:
Loosen the bolt and rotate
the disk then tighten the
bolt.
NOTE: Use the Guide Rail Bracket (#08) set
screws and/or the Glass Connector (#21) to
adjust the Guide Rail (#03) to level.
20
.
Fasten the Guide Block (#12) to
the threshold with the Countersunk
Screws ST4.2×25 (#17). (
Fig. 21)