©2017 DreamLine. All Rights Reserved
22
ENIGMA Z Enclosure Manual Ver 1 Rev 4 04/2017
20
Add Thread Lock (#20) to the
roller guard set screws to prevent
them from loosening.
Fig. 26
*Roller guards must be tight and
the distance beneath the guide rail
should be 1/16”.
roller guard
roller height
adjustment range
1
16
"
Fig. 27
!
NOTE: The door glass must be supported during this process. Use a 1/4” shim, a glass suction cup
and an assistant. Adjust the tilt of the door glass as necessary by loosening the set screws on either
side of the wheel. Raise or lower the wheel to the proper height and re-tighten the set screws.
Only adjust one wheel at a time.
24.
Position the Roller Guards on both Roller
Assemblies (#04) to within 1/16” of the
Upper Guide Rail (#03) to ensure that the
Door Glass (#05) is secure. (Fig. 27)
TIP: During door glass adjustment, you must support the door glass so that it does not make contact
with the guide block. Leave approximately 1/8” of space between the bottom of the door glass and
the guide block. Use a 1/4” shim on the threshold to prevent adjusting the door glass too low.
23
.
If necessary, the door glass can be adjusted to create a better seal with the wall. The Bumper Seal
Strip (#13) must be installed on the Door Glass before making any adjustments. Use the set screws
to raise or lower the wheels. Fully
Tighten all set screws after all adjustments are made. (
Fig. 26)