© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
15
FLEX Shower Enclosure Panel manual Ver 3 Rev 4 072019
©2019 DreamLine. All Rights Reserved
NOTE:
Measure to the edge of the door and
notch the
Bottom Sweep vinyl
(#08)
with a
razor knife to fit around the magnetic strip,
leaving the flexible sweep intact.
Fig 11
Fig 12
1
2
3
1
2
3
Ø 1/8”
Outside View
RIGHT
-
HAND
RETURN
PANEL
SHOWN
AS
AN
EXAMPLE
inside
door
return panel
door
door
panel
door
inside
view
outside
view
12.
Attach the
Vinyl Seal with Flexible Fin (#07)
to
the vertical edge of the Stationary panel glass.
Measure and cut the
Bottom Sweep vinyl (#08)
to
cover the bottom edge of the door from the pivot to
both sides of the Glass door. Attach both pieces of the
Bottom Sweep vinyl
to the bottom edge of the
Glass door.
(Fig 12)
11.
Drill holes into the aluminum profile of the
Door assembly (#02)
through the predrilled holes in the
Corner Profile (#10)
using an
Ø 1/8
drill bit. Secure the Door assembly inside the
Corner Profile (#10)
using the
ST4.0 x 10 Pan head screw
(#04)
with the raised white washers. Cover the exposed screw
heads with the
Decorative Covers (#06)
.
(Fig 11)
