© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
To create a good seal with the wall and to achieve minimal clearance beneath the door glass without making
contact with the bottom guide block or threshold.
Have at least two 3/16” shims or wedge shims (to maintain space beneath the door glass) and an assistant
available to help with this procedure.
Adjust only one wheel at a time. You may need to perform these steps more than once to get the desired results.
NOTE:
Be sure to install the Bulb Vinyl Seal onto the edge of the door glass to protect the edge from
contact with the wall during installation or adjustment.
CAUTION:
The door glass is heavy and may require two people to safely accomplish these steps.
Do Not
adjust the rollers without first securing the door glass with shims, an assistant or both.
1. First, loosen and lower either the Roller Guards (Mysterie) or Bottom Rollers (Enigma/MysterieO) to allow
enough room to adjust the upper rollers. (If you have not installed these yet, you will be instructed to in
step #7
below after these adjustments are made)
2. Loosen the safety set screw on the roller (remove and apply a drop of thread lock if not done already)
3. Loosen the wheel bolt just enough so that you can rotate the adjustment disk. (remove and apply a drop of
thread lock if not done already)
4. Rotate the adjustment disk to raise or lower the door slightly with help from an assistant. You can use a small
tool (like an allen wrench) to aid in turning this disk by inserting it into the small hole on the edge of the
adjustment disk.
5. While holding the adjustment disk in place, retighten the wheel bolt. Use a shim or have an assistant hold the
door glass in place while you retighten the wheel bolt.
6. Once satisfied with the adjustment,
it is very important to re-tighten the safety set screw
to secure the
wheel bolt in place.
7. For the Mysterie: Reposition the roller guards approximately 1/16” beneath the guide rail and retighten.
For the Enigma and MysterieO: adjust the lower rollers to make contact with the guide rail using the same
methods as described in the steps above.
Roller adjustment procedure for:
MYSTERIE
add threadlock to
the safety set screw
and wheel bolt
safety set screw
adjustment disk
wheel bolt
Roller wheel adjustment disks
Raise glass
Lower glass
The provided Thread Lock will remain workable
for approximatley 10-15 minutes before drying.
!
24
MYSTERIE shower door manual Ver 6 Rev 7 07/2018
©2018 DreamLine. All Rights Reserved