© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
Installation steps
8
MYSTERIE shower door manual Ver 6 Rev 7 07/2018
©2018 DreamLine. All Rights Reserved
Note:
The minimum threshold requirement for
the Mysterie is
2-3/4” of flat threshold space
.
Fig 1
Fig 2
W
Top
Middle
Bottom
2-3/4
”
minimum
Threshold must be level
!
Use a metal file to
deburr the cut end
door end
door end
glass bracket
holes
1.
Measure the distance between the two finished
walls at the top, middle and bottom. Measure the
width at the model height.
This top measurement will be the
“W”
dimension
used to cut the guide rail to the correct size for
the finished opening.
Also, check the threshold for level and the walls
for plumb.
(Fig 1)
2.
The
Upper Guide Rail (#03)
has been pre-cut
for the model width of 60”.
(Note: The actual rail is
shorter than the model width by design)
.
Cut the
Upper Guide Rail (#03)
from the door end only,
which is the end that is farther from the
Glass
Bracket (#07)
holes.
(Fig 2)
The length to cut off will be (
L) :
Model Width – finished opening W = cut off length (L)
*FOR EXAMPLE:
If the model width is 60” and the finished opening is 58”,
then you will need to cut 2” off from the door end of the
Guide Rail: Example: 60” – 58” = 2” cut off
*Note that this is only an example and the actual
cut-off length will vary based on the actual finished
opening dimension.
