© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
UNIDOOR (STYLE A) Single Shower Door Manual Ver 3 Rev 2 122021
16
©2021 DreamLine® All Rights Reserved
inside
inside
inside
inside
inside
inside
1
2
3
4
5
Fig 4
!
Fully and evenly tighten
the hinge bolts by hand.
It is normal to hear the
gaskets compressing onto
the glass.
NOTE
Refer to the
Hinge Assembly Adjustment Procedure
on
page 20
to adjust the closing angle of the
Hinge Assemblies (#05)
after
the door glass has been installed.
Door Glass Installation
OPTION B
: (Install the Hinges to the wall First):
TIP
Use caution when installing the hinges to the wall to avoid scratching the finished surface of the
Hinge Assembly (#05)
face plates. The manufacturer recommends using an extension driver bit to install these long screws. Painter’s Tape can also
be used to protect the hinge plates.
4
Mark holes for drilling. Remove the hinges from the door glass. Drill the holes and attach the hinges to the wall.
Set the
Door Glass (#01)
onto the 5/8” shims and use an assistant to install the door glass onto the hinges.