© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
Tools Needed
Hinge Assembly Adjustment
21
UNIDOOR (STYLE A) Single Shower Door Manual Ver 3 Rev 2 122021
©2021 Dr
eamLine® A
ll R
igh
ts R
eser
ved
wall
wall
outside
inside
90°
wall
(Example)
wall
wall
wall
outside
inside
85°
The hinge assemblies are preset to overclose to 85º for a tight seal against the
strike vinyl. The adjustment feature on the hinge assemblies is used to change the
closing angle of the door only.
For single door models, make any adjustments to the hinges before installing the
L-Strike vinyl w/VHB tape in
Step #8
.
Both the top and bottom Hinge Assemblies must be adjusted at the same time
and to the same angle during adjustment.
How to Adjust the Hinge Assemblies
set screws
!
To prevent water leakage, adjust the
Hinge Assemblies (#05)
to
overclose so the Door Glass creates a tight seal with the
L-Strike
Vinyl Seal (#08)
(for single shower door models) or the
Strike Vinyl
Seal
included with the Inline Panel or Return Panel Glass.
The Adjustable Hinge Assemblies are
factory pre-set to overclose to 85° to
create a tight seal with the Strike Vinyl.
If strike vinyl is not used, the hinges
can be adjusted to close to a different
angle (90° for example).
Once the
Door Glass (#01)
is installed:
• Hold the door in the closed position and loosen the adjustment
set screws on
both
hinges with the supplied Allen Key
• Move the door to the new desired closed position
• While holding the door in the new closed position, retighten
the set screws on
both
hinges
•
The Door Glass will now close to the new closed position
Overview of UNIDOOR
left-swing installation shown
NOTE
hinges adjusted to overclose
before installing the strike
vinyl seal
Do not adjust the hinges separately or
before installation. This could lead to
problems with the hinges operating
together correctly.
NOTE
