7mm
Page 4 of 6
1
2
3
3
Bx2
4
5
IMPORTANT
Once the feet have been
assembled and attached,
they should be adjusted to
ensure they do not touch
the floor, (7mm above the
floor) to allow for movement
once the mattress is placed
on the bed frame.
It is important to note that
when moving the bed that
it is not dragged into its new
position to prevent the
possibility of these feet
being twisted or angled to
one side, which could lead
to the collapse of the centre
of the bed.
To move the bed, remove
the mattress and lift the bed
into its new position to avoid
damage.
Ensure the feet are at 90 to
the floor before replacing
the mattress.
Place the fixed central
support "4" onto the support
block on headboard "1" and
footboard "2".
Fix the central support "4"
at both ends using screws
"B", tighten with a
screwdriver.
