Murphy Ottoman Bed - Assembly guide - Page 13
Before moving the slat frame, place a mattress on top of the slats as without a mattress in
place
the speed of movement is quick and may cause injury
so be careful
.
Carefully lower the frame with the hand-strap ensuring the frame sides are aligned with the
side rails; there should be an even gap on each side. If not aligned, check bed is still square
(see Step 7) and if it is, but gaps are still not even, re-align the
slat
frame.
Depending on the weight of the mattress, the rising speed will vary so be careful until you get
used to the speed. Always use the strap to lift or lower the frame - keep fingers well away
from the moving parts.
When fully assembled and the mattress in position, please raise & lower the ottoman 4/5
times to ensure the gas pistons are fully lubricated.
1
3
Note: Be very careful what
you store under the bed -
the top of an item, like a
suitcase or a box must not
touch the slats or they may
be damaged. Maximum
storage height is 305mm .
1
2
Push x2 Mattress Stoppers (I) into
metal frame, they should go all the
way through the upper & lower
metal sections.
I
H
