DREAVER MZD-03, User Manual

b. 

Press to set the temperature; each press to the button of the temperature “+” can 

only increase by 1, and the maximum can only be up to 48C°; the button “-“can only be 

reduced by 1 per press, and the minimum can only reach 35C°;

c. 

Perform corresponding actions in real-time according to the difference between the 

water temperature and the pre-set temperature;

d. 

When the water temperature is lower than the pre-set temperature, the heating 

functions will be automatically turned on;

e. 

When the water temperature reaches the pre-set temperature, the heating function 

will be automatically turned off; and there will be a geluid sound “di di di”.

3. 

The timing button of the remote control:

 a. 

The default time of boosting is 30 minutes countdown;

 b. 

Time setting key, the highest setting is 60 minutes, the lowest setting is 10 minutes;

c. 

The system will shut down immediately after the 30 minutes countdown and a beep 

“di” is issued;

4. 

The bubble/red-light function part of the remote control:

 a. 

Press the button to turn on the red-light function and bubble function in cycles;

5. 

The massage function part of the remote control:

a. 

Press the button to turn on the three modes of the massage function in cycles;

REPLACE THE CONTROL BATTERY

»

  Remove the battery box from the remote control and take out the original battery.

»

  Install the CR2025 button battery on the battery box, please pay attention to the negative 

and positive poles of the battery

 (positive electrode down)

. Install the battery box with 

the battery on the remote control.

»

  The remote control with a new battery.

When the water temperature < the set temperature 2C°, it will reheat. When the water 

temperature > the set temperature, the heating will be stopped , and the water temperature 

will be maintained by circulating heating;

WATER TEMPERATURE CONTROL

English

DREAVER - FOOT SPA MA SSAGER

5