dresden elektronik ingenieurtechnik gmbh
Tel: +49 351 31850-0 Fax: -10
Kontakt
Enno-Heidebroek-Str. 12
wireless@dresden-elektronik.de
01237 Dresden | Germany
www.dresden-elektronik.de
© 2019 dresden elektronik ingenieurtechnik gmbh. Alle Rechte vorbehalten. Alle Warenzeichen, eingetragene Warenzeichen
und Produktnamen sind das Eigentum der jeweils Berechtigten. Für die Aktualität, Vollständigkeit und Richtigkeit der
enthaltenen Informationen können wir keine Garantie übernehmen. Technische Änderungen vorbehalten.
RF exposure considerations
The module is approved as mobile device and therefore can be placed at least 20 cm away from any
user.
Antennas
The module has an integrated PCB antenna. There is no option provided to connect a different
antenna.
Label and compliance information
If the FCC identification number is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to the
enclosed module. This exterior label can use wording such as the following:
“Contains FCC ID: XVV-RASPBEE2”
Information on test modes and additional testing requirements
Test modes are available with Atmel Studio. For further information contact us.
Additional testing, Part 15 Subpart B disclaimer
As long as these conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.). Host product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed.
Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user's manual of the end product which integrates this module. The
end user manual shall include all required regulatory information/warning as shown in this manual.
Innovation, Science and Economic Development (ISED) Canada
IC: 8720A-RASPBEE2
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Ec
onomic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage.
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
This equipment complies with radio frequency exposure limits set forth by ISED Canada for an
uncontrolled environment.
Cet équipement est conforme aux limites d'exposition aux radiofréquences définies par ISDE Canada
pour un environnement non contrôlé.
