SECTION 4
OPERATING
Page 24
OM515C520C99/1E
DRESSTA
4.6. SEAT BELT
The seat belt is for operator's safety and should be worn at all times while operating the machine.
Adjust the seat to the desired position before fastening the seat belt.
WARNING: DO NOT use bleach, dye, or solvents on the seat belt, because this
may weaken the webbing and result in personal injury. Clean the seat belt with
warm water and a mild detergent. Replace belts with worn, frayed, torn, faded,
stiff, or rotted webbing.
WARNING: Before driving the machine, adjust the seat and fasten the seat belt
Adjust the seat belt to fit snugly and low around the hips to lessen the chance
and severity of injury in the event of an accident. NEVER wear the seat belt
across the abdomen.
Fig. 4.16. Seat Belt
1. Belt
2. Buckle
3. Tang
Fasten the belt and remove it in the following manner:
1. Adjust the seat so that the brake pedal can be depressed all the way with the operator's back
against the backrest.
2. With the seat unoccupied, tense belt (1) lightly across the seat and install. Check that there are
no kinks in the belt.
3. Sit in the seat. Hold buckle (2) and insert tang (3) into the buckle. Check that the bet has locked
by pulling it.
4. When removing the belt, raise the tip of the buckle lever to release it.
When leaving the operator's seat, release the seat belt and hang it over the arm rest.
Fasten the belt across your body without kinking it. Adjust the lengths of the belt on both the buckle
and tang ends so that the buckle is located at the mid-point of your body front.
Adjust the belt length in the following manner:
1. To shorten the belt, pull the free end of the belt at either the buckle or tang end or at both ends.
2. To lengthen the belt, pull the belt while holding it at a right angle to the buckle or tang.
Summary of Contents for 515C
