OPERATING INSTRUCTIONS
Empty the spray-gun of any residual paint into a separate spills-dish.
Open the main valve for compressed air (item 7 illustration 1).
Open the lid for the automatic washer (make sure it `clicks` into the full open position).
Place the spray-gun inside (see illustration 5).
Be sure to fit the trigger clip following illustration 6, and to push the spray-gun up against the nozzle for the paint-
channel (item 1 illustration 5) before you lock it into position with aid of the magnets of the trigger clip.
If you prior to cleaning prefer to remove the Air-cap and the needle of the spray-gun, then place those items as shown
by arrow 5 in illustration 5.
Close the lid, and start the automatic pre-wash cycle by pressing the foot pedal No.8B illustration 1. The spray-gun will
now be automatically cleaned for approx. 1.5 minutes with circulating solvent.
When the cleaning procedure is completed, the lid can be opened and the spray-gun taken out. It can now be manually
further washed or rinsed with water.
By pressing foot pedal No.10B in illustration 1, recirculating water will be fed through the cleaning brush placed in the
sink (item 1 illustration 7B). Note that the ball-valve on the brush (item 6 illustration 7B) must be in an open position.
The spray-gun’s paint channel can now be rinsed with clean water. Press the tapered nozzle of the rinse-gun (item 2
illustration 7B) against the paint channel of the spray-gun. Pull the triggers on the spray- and rinse-guns simultaneously.
Then rinse the outside of the spray-gun with the rinse-gun.
The brush and rinse-gun in the sink can be used independently of the automatic washer at any time.
Connect the spray-gun to the air-line on the left side of the machine (item 4 illustration 1), and blow out the spray-gun
through the funnel in the sink (item 3 illustration 7B). By using this funnel, you prevent the fumes from spreading within
the premises.
Finally, the spray-gun can be blown dry by using the air-gun on the right side of the unit (item 12 illustration 1).
Close the lid after cleaning.
OPERATION WITHOUT TAP-WATER CONNECTION
If tap water is not available at the site of the gun-cleaner, you have the option to use recycled water (obtained from the
filtering process) for the rinse-gun as well as the cleaning brush
In that case the machine should be reconnected as follows:
Disconnect the hose for the rinse-gun (item 1 illustration 9) from the valve-panel, remove the red plug from the cross-
junction on the pump (item 2 illustration 9) and fit the hose in it´s place.
The wash-brush as well as the rinse-gun in the sink will now both operate with recycled water by pressing foot-valve
10B illustration 2.
When using the rinse-gun, the valve on the wash-brush (item 6 illustration 7B) must be closed.
Summary of Contents for Boxer D44C QUATTRO Combi
Page 3: ......
Page 15: ......
Page 17: ...APPROPIATE AUTHORITY INFORMATION FROM THE PAINT SUPPLIER MAY BE NECESSARY ...
