User Manual
STOVE BUILT-IN | ALEMANIA 60 INDUCTION
25
There are ventilation holes around outside of the hob. YOU MUST ensure these holes are not blocked by the worktop
when you put the hob into position.
Be aware that the glue that joins the plastic or wooden material to the furniture has to resist to temperature not below
150
℃
, to avoid the unstuck of the paneling.
The rear wall, adjacent and surrounding surfaces must therefore be able to withstand a temperature of 90
℃
.
13. BEFORE LOCATING THE FIXING BRACKETS
•The work surface is square and level, and no structural members interfere with space
requirements.
•The work surface is made of a heat-resistant and insulated material.
•If the hob is installed above an oven, the oven has a built-in cooling fan.
•The installation will comply with all clearance requirements and applicable standards and
regulations.
•A suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring mounted and positioned to comply with the local wiring
rules and regulations.
•The isolating switch must be of an approved type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow for this
variation of the requirements).
•The isolating switch will be easily accessible to the customer with the hob installed.
•You consult local building authorities and by-laws if in doubt regarding installation.
•You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces
surrounding the hob.
AFTER INSTALLING HOB, MAKE SURE THAT
•The power supply cable is not accessible through cupboard doors or drawers.
•There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
•If the hob is installed above a drawer or cupboard space, a thermal protection barrier is
installed below the base of the hob.
•The isolating switch is easily accessible by the customer.
